Description
Details
Manufacturer: Tripp Lite
Model: Tripp Lite SmartPro UPS LCD 1500VA 900W, Tower, 120V, 15A
Condition: New batteries, refurbished UPS
Part Number: SMART1500LCDT
Maximum output: 900W / 1500VA
Typical backup time at half load: 10 minutes (450 Watts)
Typical backup time at full load: 4 minutes (900 Watts)
Warranty: 1 year full replacement warranty
Tripp Lite SmartPro LCD 1500VA 900W Tower 120V SMART1500LCDT Manual
SMART1500LCDT - Tripp Lite SmartPro LCD 1500VA Specifications:
Input:
Rated input current (Maximum Load) |
12A |
||
Nominal Input Voltage(s) Supported |
120V AC |
||
UPS Input Connection Type |
|
||
Input Circuit Breakers |
20A |
||
UPS Input Cord Length (ft.) |
6 |
||
UPS Input Cord Length (m) |
1.8 |
||
Recommended Electrical Service |
15A 120V |
||
Input Phase |
Single-Phase |
Output:
Output Volt Amp Capacity (VA) |
1500 |
||
Output kVA Capacity (kVA) |
1.5 |
||
Output Watt Capacity (Watts) |
900 |
||
Power Factor |
0.8 |
||
Nominal Voltage Details |
120v nominal output in battery mode |
||
Frequency Compatibility |
50 / 60 Hz |
||
Frequency Compatibility Details |
Automatic frequency selection |
||
Output Voltage Regulation (Line Mode) |
120V (+9% / -12%) |
||
Output Voltage Regulation (Battery Mode) |
120V (±10%) |
||
UPS Output Receptacles (Surge Suppression Only) |
5 UPS outlets, 5 surge-only outlets |
||
Load Management Receptacles |
Two switchable single-outlet 5-15R load banks |
||
Output AC Waveform (AC Mode) |
Sine wave |
||
Output AC Waveform (Battery Mode) |
PWM sine wave |
||
Nominal Output Voltage(s) Supported |
110V; 115V; 120V |
||
Output Receptacles |
|
||
Individually Controllable Load Banks |
No |
Battery:
Half Load Runtime (min.) |
10 minutes (450 watts) |
DC System Voltage (VDC) |
24 |
Battery Recharge Rate (Included Batteries) |
Less than 8 hours from 10% to 90% |
Internal UPS Replacement Battery Cartridge |
RBC51 (requires 2) |
Expandable Runtime |
No |
Voltage Regulation:
Voltage Regulation Description |
Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 92 to 150 |
Overvoltage Correction |
Input voltages between 129 and 147 are reduced by 15% |
Undervoltage Correction |
Input voltages between 92 and 108 are boosted by 18% |
User Interface, Alerts & Controls:
Front Panel LCD Display |
LCD screen with scroll buttons indicates Input voltage, Output voltage, Frequency (Hz), AVR boost / cut status, |
Switches |
Power switch offers whole UPS power control; Scroll/mute button enables LCD selection options and silences audible alarm; Test button initiates self test |
Alarm Cancel Operation |
Power-fail alarm can be silenced using alarm-cancel switch |
Audible Alarm |
Audible alarm indicates power-failure and low-battery conditions |
Surge / Noise Suppression:
UPS AC Suppression Joule Rating |
650 |
UPS AC Suppression Response Time |
Instantaneous |
UPS Dataline Suppression |
1 line TEL/DSL (1 in / 1 out); 10/100Base T Ethernet; Coax jacks (1 set) |
EMI / RFI AC Noise Suppression |
Yes |
Physical:
Cooling Method |
Fan
|
Primary Form Factor |
Tower
|
Primary UPS Depth (mm) |
391
|
Primary UPS Height (mm) |
203 |
Primary UPS Width (mm) |
146 |
Shipping Dimensions (hwd / in.) |
11.10 x 9.00 x 19.30 |
Shipping Weight (kg) |
12.70 |
Shipping Weight (lbs.) |
28.00 |
UPS Housing Material |
Steel |
UPS Power Module Dimensions (hwd, cm) |
20.32 x 14.60 x 39.12 |
UPS Power Module Dimensions (hwd, in.) |
8 x 5.75 x 15.4 |
UPS Power Module Weight (kg) |
12.25 |
UPS Power Module Weight (lbs.) |
27 |
Environmental:
Operating Temperature Range |
+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
|
Storage Temperature Range |
+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius |
Relative Humidity |
0 to 95%, non-condensing |
AC Mode BTU / Hr. (Full Load) |
119 |
Battery Mode BTU / Hr. (Full Load) |
867 |
AC Mode Efficiency Rating (100% Load) |
95% |
Communications:
Network Monitoring Port Description |
Supports detailed monitoring of UPS and site power conditions |
PowerAlert Software |
For local monitoring via the UPS’s built-in USB port, download PowerAlert Local software at |
Communications Cable |
USB / Not included |
WatchDog Compatibility |
Supports Watchdog application, OS and hard-reboot restart options for remote applications |
Communications Interface |
USB (HID enabled) |
Additional Info
Additional Info
Manufacturer | Tripp Lite |
---|---|
Form Factor | Tower |
Waveform in Battery Mode | Pure Sinewave |
Input Voltage | 120V AC |
Output (VA) | 1500VA |
Output Voltage | 120V AC |
PDU Total Outlets | No |