Tripp Lite Smart Pro UPS 500VA 300W 120V 15A Output: (6)5-15R SMART500RT1U - Refurbished

Rated input current (Maximum Load)

10A

Nominal Input Voltage(s) Supported

120V AC

UPS Input Connection Type

Input Circuit Breakers

10A

UPS Input Cord Length (ft.)

10

UPS Input Cord Length (m)

3.1

Recommended Electrical Service

15A 120V

Input Phase

Single-Phase

Output Volt Amp Capacity (VA)

500

Output Watt Capacity (Watts)

300

Output kW Capacity (kW)

2.4

Output Capacity Details

4.2A @ 120V. (LINE MODE) 120% @ 5 minutes; (BATTERY MODE) 120% @ 5 seconds

Power Factor

0.6

Nominal Voltage Details

120V sinusoidal in line mode and 120V PWM in battery mode

Frequency Compatibility

60 Hz

Frequency Compatibility Details

Output is regulated to +/-0.05Hz when input frequency exceeds +/-5Hz of nominal.

Output Voltage Regulation (Line Mode)

-14%, +16%

Output Voltage Regulation (Battery Mode)

+/- 5%

UPS Output Receptacles (Surge Suppression Only)

5 UPS outlets, 1 surge-only outlet

Load Management Receptacles

One switchable single-outlet 5-15R load bank

Output Circuit Breakers

15A branch rated (x2) - each breaker protects 4 outlets, L5-30R is unbreakered

Output AC Waveform (AC Mode)

Sine wave

Output AC Waveform (Battery Mode)

PWM sine wave

Nominal Output Voltage(s) Supported

120V

Output Receptacles

Individually Controllable Load Banks

Yes

Battery Type

Valve Regulated Lead Acid (VRLA)

Full Load Runtime (min.)

3 min. (300w)

Half Load Runtime (min.)

14 min. (150w)

Expandable Battery Runtime

Supports extended runtime with optional external battery packs

Expandable Runtime

No

DC System Voltage (VDC)

12

Battery Recharge Rate (Included Batteries)

Less than 12 hours to 90%

Battery Access

Battery access door

Internal UPS Replacement Battery Cartridge

IMPORTANT BATTERY REPLACEMENT INFORMATION > Use Tripp Lite RBC12V-1U replacement battery for SMART500RT1U models with Series Number AG-03AA listed on the UPS nameplate (sold starting in 2021); For all prior versions of SMART500RT1U, use Tripp Lite  RBC62-1U  replacement battery; Contact Tripp Lite customer service for additional information

Battery Replacement Description

Hot-swappable, user replaceable batteries

Voltage Regulation Description

Automatic voltage regulation (AVR) maintains line power operation with input voltage as low as 90 (±5%). Input voltage range of 90 to 139

Undervoltage Correction

Input voltages between 90 and 105 (±5%) are boosted by 14%

Switches

2 Switches control off/on power status and alarm-cancel/self-test operation

Alarm Cancel Operation

Power-fail alarm can be silenced using alarm-cancel switch

Audible Alarm

Audible alarm indicates power-failure, overload and low-battery conditions

LED Indicators

5 LEDs indicate line power, battery power, overload, voltage regulation and battery low/replace status

UPS AC Suppression Joule Rating

567 J

UPS AC Suppression Response Time

Instantaneous

EMI / RFI AC Noise Suppression

Yes

Primary Form Factor

Included Mounting Accessory Description

Installation Form Factors Supported with Included Accessories

Minimum Required Rack Depth (cm)

Minimum Required Rack Depth (inches)

Primary UPS Depth (mm)

Primary UPS Height (mm)

Primary UPS Width (mm)

440

Rack Height

1U

Shipping Dimensions (hwd / cm)

10.67 x 39.88 x 54.10

Shipping Dimensions (hwd / in.)

4.20 x 15.70 x 21.30

Shipping Weight (kg)

8.67

Shipping Weight (lbs.)

19.12

UPS Housing Material

Steel

UPS Power Module Dimensions (hwd, cm)

4.39 x 43.99 x 28.60

UPS Power Module Dimensions (hwd, in.)

1.73 x 17.32 x 11.26

UPS Power Module Weight (kg)

7.18

UPS Power Module Weight (lbs.)

15.84

Operating Temperature Range

Storage Temperature Range

+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius

Relative Humidity

0 to 95%, non-condensing

AC Mode BTU / Hr. (Full Load)

48

AC Mode Efficiency Rating (100% Load)

97%

AC Economy Mode Efficiency Rating (100% Load)

0.97

Operating Elevation (ft.)

6561 ft. (2000 m) above sea level

Audible Noise

45 dBA maximum, front side 1m

Network Management Cards

Compatible with: SNMPWEBCARD55, WEBCARDLX.

Network Monitoring Port Description

Supports detailed monitoring of UPS and site power conditions

PowerAlert Software

For local monitoring via the UPS’s built-in communication ports, download PowerAlert Local software at https://www.tripplite.com/poweralert

Communications Cable

USB and DB9 cabling

WatchDog Compatibility

Supports Watchdog application, OS and hard-reboot restart options for remote applications

Network Management Card Description

Optional Network management card

Communications Interface

DB9 Serial; EPO (emergency power off); Slot for SNMP/Web interface; USB (HID enabled)